Restore
pitcher's energy
Wait until your
pitcher has low energy then pause game play. If your pitcher is still on the
mound, go to "Save Game and Quit", then save the game. Restart the
system, and when you go to the main menu, load the game. When you finish
loading, it should automatically take you back to the game, and it should show
your pitcher on the mound with the full green energy bar.
View
player's energy in franchise mode
When at the main
menu in franchise mode, go to "GM Office", then "Roster
Management", then "Disabled List". Look through your players to
see which ones are tired (except pitchers). If a starting player is tired, you
should bench and rest him for one game.
Change
jerseys in franchise mode
Before playing in a
franchise mode game, go to quick play, and on the team's options highlight
"Change Uniform". Go back, exit quick play, load the franchise, and
when you get to the play game screen on options, your pointer will be on the
blacked out uniform part. Press A and you can change uniforms. Once you change
lineups or pitchers, this option is no longer available; it only works for that
one game.
Demote
player without other teams claiming him off waivers
Go to the player
editor and make all his stats to D- so that no teams would want to claim him
off waivers. When you want to promote a player back to the Major Leagues,
change his ratings back to his default settings.
Easy
points
Start a two player
game, with only one actual player. Throw a perfect game, striking out every
batter. Save the game in the bottom of the ninth inning with two strikes and
two outs. Finish the game, collect your points, and save the options. Reload
the game and repeat to collect the points again. Change to the team that you
are facing and make them play poorly, allowing your original team to score a
lot of runs. In the last inning, switch back to your team and claim your team's
cheaply made points.
Free
balls
If you are down in
the count or need a quick ball, pretend to lay down a bunt. Pull back while the
pitcher is in his motion. This should result in a ball being thrown. Note: This
only works up to two times in an at bat.
Throw
hard 4 seam fastball correctly
If you have a
pitcher or created player that throws a hard 4 seam fastball, always place the
pitching cursor below where you want the pitch to go. The pitch will
automatically rise after the pitcher releases it. However, with other pitches
(curveball, slider, changeup, etc.) the ball will end up where you put the
pitching cursor.
-----------------------------------------------------------------------------------------
Get
Tons of Points:
Start a two-player
game and proceed to strike out every batter on each side until the bottom of
the ninth inning.
When you've got two
outs at the bottom of the ninth, walk the next four hitters to earn enough points to buy 100 card packs,
which should get you almost every card. If not, repeat and get yourself more
card packs.
No comments:
Post a Comment